Thanks Don
That is what I have tried to do. My rotor plate does not fit ?just above
the horizontal Z brace. It will not physically tip into place except about
½ the way between two horizontal braces. I have not resorted to the large
hammer approach yet however. My objection is that there is no support for
the plate to sit on. I have fashioned a brace for the plate to sit on out
of some aluminum angle stock. I am using a thrust bearing so there will not
be any weight on the plate except the rotor (T2x). Maybe I am worrying
about something I don?t need to worry about. I need to measure the plate,
something I still have not done despite suggestions from you all. So lets
see where is my measuring device????
mike
K8ZE
k8ze@charter.net
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|