----- Original Message -----
From: Chuck Lewis
To: Jerry Keller
Sent: Thursday, July 22, 2004 4:21 PM
Subject: Re: [TowerTalk] Re: Thrust bearing
----- Original Message -----
I figure the less weight that bears on the rotator, the longer it will
last.... and TB's are cheaper than rotators!
N4NM comment:
I have always been taught that ball and roller bearings must be properly
preloaded to prolong life. Granted, these rotor bearings are running at
really slow speed, so it's not the same issue as a wheel bearing on a race
car, but intuition tells me that axial loading (within manufacturer's specs)
is beneficial in maintaining bearing alignment and reacting against lateral
(shear) loads through the plane of the bearing. I seem to remember seeing
that corroborated by a rotor manufacturer, but I can't quote the specifics.
Can anyone with some credentials weigh in here? Having a "thrust" bearing to
take the vertical load is like Mom and Apple Pie. If it's a misconception,
we need to refute it, but if the "thrust" bearing tradition is correct, I
need to crawl into my hole and shut up.
73,
Chuck, N4NM
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|