In a message dated 9/20/2004 12:07:21 PM Eastern Standard Time,
towertalk-request@contesting.com writes:
Has anyone come up with a method of attaching a small VHF or UHF antenna at
or near the top of one of one the intermediate sections of a US towers or
similar crank up without interfering with the tower's operation (up - down)?
Thanks,
Ken W7TS
========================
Ken,
I have done this many times on both Tri-EX and US Towers, by adding a bracket
to support the VHF antenna to one of the tower section top tie plates. This
requires drilling a couple holes in that plate, but 1/4" or 5/16" holes will
not effect the strength. Fot the added bracket I have used both angle or round
stock depending on the antenna to be supported.
Regards,
Norman W4QN
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|