my Yaesu rotor lines up just fine with my rohn rotor plate the plate has
elongated holes does yours
JESS COLVIN (AI9L)
ai9l@core.com
http://my.core.com/~ai9l/
http://www.qsl.net/ai9l
Outgoing mail is Checked by
NORTON anti-virus system
----- Original Message -----
From: "Julio Peralta" <jperalta@tampabay.rr.com>
To: <TOWERTALK@contesting.com>
Sent: Tuesday, November 02, 2004 6:02 AM
Subject: [TowerTalk] Rotor plates
> we getting ready to complete our tower installations at the Tampa Radio
Club when these problems came up.
>
> #1 we noticed that the factory drilled holes in a Rohn 25 rotor shelf do
not line up with a TB-3. What is the best why to make that happen?
>
> #2 We have the same problem with a Yeasu rotor. The mounting holes don't
match the hole pattern in a R25 rotor shelf. What is the best way to make
this happen?
>
> Julio. W4HY
> _______________________________________________
>
> See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any
questions and ask for Sherman, W2FLA.
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|