The plate on mine rest on the z braces not the clamp on type, so you cant
adjust its location. It goes in only one way. I raised the rotor above the
plate with couple pieces of square Channel
Thanks for the hints for mounting the M2
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of KJ6Y@aol.com
Sent: Monday, September 12, 2005 10:20 AM
To: n5ff@comcast.net; gfisher100@frontiernet.net; towertalk@contesting.com
Subject: Re: [TowerTalk] [BULK] - Tashjian Towers
You raise the plate, not the rotor.
I should probably climb my tower and take a digital picture and post it.
Maybe in my spare time.
The M2 2800 will fit very nicely into the LM-470. You might have to take
the clamps off to get it inside but it will fit. Being a triangle design,
rotate it so the sides are parallel with the tower sides. Drill out the
mounting
holes to accommodate the 3/8" bolts on the bottom. I also recommend the
safety wire kit available from M2.
Skip, KJ6Y
_Communications Service Co_ (http://members.aol.com/kj6y/skip.html)
818-887-3569
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any
questions and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|