Towertalk
[Top] [All Lists]

Re: [TowerTalk] Is that really Rohn?

To: "Jim Jarvis" <jimjarvis@verizon.net>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] Is that really Rohn?
From: "Terry Gerdes" <terry@ab5k.net>
Date: Sat, 29 Apr 2006 13:20:32 -0500
List-post: <mailto:towertalk@contesting.com>
Jim,

You are right it certainly could be a clone tower.   This was formerly a 
Loran tower and probably purchased for the government on a lowest cost 
basis.  I would certainly like to think that it a clone and was manufactured 
to a lower spec.  It looks like a swaged reduction but the reduction is very 
sharp.   I compared it with some other R25 tower sections and they have a 
tapered swag.  I cut another leg off the tower section and posted a couple 
of pics:

http://www.ab5k.net/images/R25_1.jpg

and

http://www.ab5k.net/images/R25_2.jpg

73 Terry - AB5K


----- Original Message ----- 
From: "Jim Jarvis" <jimjarvis@verizon.net>
To: <terry@ab5k.net>; <towertalk@contesting.com>
Sent: Saturday, April 29, 2006 11:23 AM
Subject: Is that really Rohn?


>
> I looked at the .jpg at the link:
>
> http://www.ab5k.net/images/LoranTowerLeg.jpg
>
>
> It appears that the 'inner' section is a tube
> welded inside the outer, not a swaged reduction, like Rohn.
> Additionally, I've never seen Rohn 25 with a welded-
> on slug on the outside...visible just under the
> rust-through section.
>
> Is it possible this was a knock off, rather than
> actual Rohn?  Or, is my experience with Rohn 25 more
> limited than I thought?
>
> Based on the pic, it appears to me that the rust developed
> where the tower wasn't galvanized...on the inner tube, inside,
> above the weld, and on the lower surface of the aforementioned slug.
>
> It suggests that the structure was not hot-dip galvanized after welding,
> which was a Rohn spec.
>
> N2EA
>
> 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>