I often was successful by using Coke.
Let it soak for a night, either in a tub or with the tubing filled with it.
73
Peter
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Robert Chudek - K0RC
Sent: Freitag, 30. Juni 2006 17:36
To: towertalk@contesting.com
Subject: [TowerTalk] Un-nesting aluminum elements...
Guys with ideas...
I am trying to remove a 3/4" aluminum element end from a swaged 1-1/4"
element. I don't think these have been apart in 30 years. What tricks do you
guys have up your sleeve to help me separate these two pieces of tubing?
Using vise grips on the smaller section I was able to rotate the element and
move it back about an inch, but that's as far as it has gone. I'll be
chewing up the smaller tubing if I continue this route.
I've soaked the connection with LPS lubricant overnight but thought I would
put out a call for ideas before giving it another go today...
TIA
73 de Bob - K0RC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|