Hi Bob
Here is an old trick from KH6IJ many years ago.
Crimp a screwdriver (with the handle towards the boom) to the end of the
element you wan't to remove with a pair of vice grips. Smack the
screwdriver (one you don't care if it breaks or now) with a hammer and that
will drive the element out. 73 and GL
Tom W7WHY
> Guys with ideas...
>
> I am trying to remove a 3/4" aluminum element end from a swaged 1-1/4"
> element. I don't think these have been apart in 30 years. What tricks do
> you guys have up your sleeve to help me separate these two pieces of
> tubing?
>
> Using vise grips on the smaller section I was able to rotate the element
> and move it back about an inch, but that's as far as it has gone. I'll be
> chewing up the smaller tubing if I continue this route.
>
> I've soaked the connection with LPS lubricant overnight but thought I
> would put out a call for ideas before giving it another go today...
>
> TIA
>
> 73 de Bob - K0RC
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|