I use a copper or aluminum plate with stainless steel 2-3 inch #8 or 10
hardware. I then use some of the larger
solder/crimp lugs. I try to insert as many radial wires in each lug as
possible. Seems to work real well and is not
expensive or difficult to use.
I have a pair of verticals on 160, 80, and 4-squares on 40 and 20. That equals
a lot of radials (I calculate about
4.33 miles and growing!)
73
On 20 Aug 2006 at 18:45, DOUGLAS SNOWDEN wrote:
> I am putting up a vertical for 40m. Yes, I know, but this is all I can put up
> at the moment. I was thinking that I could use a few of those bus
> connections like a circuit breaker panel has. You slide the wire in ans
> tighten the screw. Seems like it would be a whole lot quicker than other
> methods. Are there other methods like that you guys have used?
>
> Doug, N4IJ Harrah, OK
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|