Harbor Freight (sigh .. again) has their 1" SDS Rotary Hammer Kit on sale
for $59.99 -- extra bit set is $9.99, buy one .. hard to find SDS bits ..
cut off a bit to make a blunt end, put a deep well socket over the shaft,
and bang away .. better yet, sacrifice a china cheapo socket and weld it in
place. I just got their e-mailed coupon for one of the Hammer kits, 20 bux
off.. in store only ..so only $40 --- I have one, worky worky!
PS -- also 6" digi caliper for $6 --way handy for us old folks for figuring
ID/OD !!
XYL, WA6MJB, won't let me take credit cards into their store, but I have a
mini VISA stashed for those "special deals" HIHI...
Mark Nelson - AA6DX
mailto: AA6DX@ARRL.NET
----- Original Message -----
From: "Allen R. Brier" <britech@earthlink.net>
To: "'Tower Talk Reflector'" <towertalk@contesting.com>
Sent: Sunday, August 13, 2006 10:32 PM
Subject: [TowerTalk] Sinking ground rods
What is the best/easiest method to sink ground rods? I know the trick of
using water to fill the hole several times to make it easy, but I have also
heard that the ground contact is not as good using this method vs. pounding
the rod in the hard way, in dry ground. Which is best?
Allen Ross Brier, N5XZ
____________________________________________
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|