I suspended mine from 2 X 4's laid across the hole, using the same kind of
wire I used to tie the pieces of rebar together. After the concrete was
poured, I shoved diagonal cutters down into the poured concrete and clipped
off the wires beneath the surface, and then made sure I smoothed over the
hole where I removed the cutters.
Then I immediately washed the concrete off the cutters.
_______________________________________________________________
This message was typed using the DVORAK keyboard layout.
http://www.mwbrooks.com/dvorak/
http://gigliwood.com/abcd/
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|