Correction in formula:
(h2^2 + r^2) ^ 0.5 - (h1^2 + r^2) ^ 0.5
( had extra close paren after h1^2 )
----- Original Message -----
From: w2id@optonline.net
Date: Monday, October 30, 2006 1:13 pm
Subject: Re: [TowerTalk] Adding tower height
To: Bryan Bydal
Cc: towertalk@contesting.com
> Hi Bryan,
>
> When you originally put up this tower, did you leave enough
> extra length in the guys to raise them up the tower a few feet?
>
>
> Pythagorus will tell you how much extra (currently unused)
> length you will need when you raise each guy:
> (h2^2 + r^2) ^ 0.5 - (h1^2) + r^2) ^ 0.5 feet of guy,
> where h1 is the original (lower) height, h2 is the new (heigher)
> height for that guy, and r is the horizontal distance to the
> anchor, assuming it is at the same elevation as the tower base.
>
> Have fun!
>
> John
> W2iD
>
>
>
> ----- Original Message -----
> From: Bryan Bydal
> Date: Monday, October 30, 2006 12:30 am
> Subject: [TowerTalk] Adding tower height
> To: towertalk@contesting.com
>
> > I had asked questions earlier about this project and have a
> few more.
> >
> > I am adding 20 ft to a 100 ft existing 45g tower I built 7
> years
> > ago. All antennas are now off the top and I need to remove the
> > flat-top top section.
> >
> > The plan is to loosen the top set of guys and move the bracket
> > down about 3 ft to the top of the next straight section. Set
> > "modest" guy tension.
> > Then remove the top section and lower it down.
> > Then move the middle set of guys up to the new height of 75ft.
> > Set modest tension on those guys.
> > Climb down and move the lowest set up to their new height of
> 35 ft.
> > Set the guy tension of the middle and lower sets of guys to spec.
> > Raise the 2 new straight sections and the top section into place.
> >
> > Move the top set of guys up to their new height of 111ft.
> >
> > The guys are connected to the rohn guy bracket assembly and I
> > would like to disconnect the guy wires at the anchors and move
> > them as an assembly up to the next guy point.
> >
> > Again, while doing the guy moving, I will keep only modest guy
> > tension on the upper guys to reduce downward force while
> moving
> > guy wires.
> >
> > Does that sound like the proper procedure for this project?
> > Thanks,
> > Bryan W5MX
> > _______________________________________________
> >
> >
> >
> > _______________________________________________
> > TowerTalk mailing list
> > TowerTalk@contesting.com
> > http://lists.contesting.com/mailman/listinfo/towertalk
> >
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|