I put up an HDX-555 + tilt-over to support a 3-el. SteppIR, but I was
allowing for an upgrade to the 4-el. and to the 30/40 add-on. plus the
addition of VHF/UHF antennas. This county may experience wind speeds of
80mph or more; I see your current QTH is Seminole County, FL, where wind
speeds may exceed 100mph. Does the city or county building dept. have
any say in what you put up?
Alan NV8A
On 04/29/07 03:28 pm W4LDE-Ron wrote:
> As a new member to the group I am looking for some advice, looks like a
> move is in the workings and I have received approval from the
> Architectural board at the new QTH to place a crank up tower on the back
> of my new property, nested at about 22ft and rising to about 55ft when
> in use. I will need, due to age, a till over for work on a beam.
>
> I will be installing either a SteppIR 3-el (42# and 6.1sq ft wind load)
> or a Sommer XP-506 (71# and 11sq ft wind load) on the top. I have looked
> at the MA-550 and TX-455 line of towers but I would appreciate any
> suggestions or recommendations you might provide.
>
> May try to support a center feed zepp for 80-40-30 from the tower but
> the 1.5 acres has lots of trees, the builder will be clearing an area
> for the tower in the back section of trees, that’s an additional
> question on how much should I clear, I am lucky that I got the approval
> and thus I want to keep things out of sight as much as I can. Ideas please
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|