Clint, our club web page www.sdxa.org has a link to a set of impedance
measurements of bead and solenoid baluns at different frequencies. Click DX
tips and you will be led to the measurements. 73, Dan, N5AR
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com]On Behalf Of Clint Talmadge
Sent: Thursday, June 14, 2007 10:00 AM
To: towertalk@contesting.com
Subject: [TowerTalk] Ferrite Balun on a LPDA?
I am close to putting my Tennadyne T-6 back up. When I took it down it had
the prescribed Coax Balun on it and it showed it's age. For the last month
or so I have had the antenna on a short perch in the yard with a Ferrite
Bead Balun on it and it sweeps fine using an analyzer and I have even made a
few DX contacts on it. The balun I am using is a W2AU by Unadilla. I have
searched different archives and the only one with any significant
information is one I started on eHam some years ago.The old Tennadyne maker
specifically said he had not tested a ferrite balun and did not recommend
them. The reasons I would like to use the Ferrite Balun are:
Lower profile - less wind resistance
Longer life - better built than my taped Coax Balun
Better Balance - the antenna is much closer to being balanced (weight wise)
with the Ferrite Balun
There is precious little written about feeding LPDAs. What little I have
read does not address this.
I am open to suggestions as the antenna will not go up till some time in
early July.
Clint - W5CPT
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|