I have a Force 12 C-3 hf beam and the manual told me to use a balun or a choke
to connect the feedline to the driven element.
I originally used a home wound choke of RG-213 on a piece of 4" pvc pipe. I
want to know if I use a high power 1-1 current balun such as a
DX Engineering DXE-BAL050-H10-A will it improve anything? Using just the choke
I have problems with RF in the shack.
How would I connect the terminal end of the balun to the driven element?
Ladderline if so which type, or short pieces of solid 12 ga insulated
electrical wire to the wing nut terminals. I understand to strap the balun to
the boom with hose clamps just behind the driven element. Is the length of the
feedline important? Do I need to make it 1/8 wave of the lowest frequency
multiples?
I hope this balun does not burn out easily. I run a Titan 425 amp. I
sometimes run AM.
I also have a 1/2 wave 75 meter dipole fed with RG-213. Would I benefit from
switching to ladderline? My tuner has a input for ladderline.
Thanks in advance for advice and 73. Jim WB5OXQ
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|