The link you provided has a link to a PDF which calls the cap you have
Non-Polarized. I think what you have will work fine. I got mine from the local
HVAC guy. I will build a test cable tomorrow and report back.
Clint - W5CPT
----- Original Message -----
From: kd4e
To: Steve Katz
Cc: TowerTalk@contesting.com
Sent: Friday, June 29, 2007 10:13 PM
Subject: Re: [TowerTalk] Polarized Electrolytic in Rotator Box?
This is *supposed* to be a starting cap but I see a
"-" next to one terminal - that made me nervous.
Perhaps I am wrongly assuming that the "-" mark
next to one terminal (nothing next to the other)
indicates that it is polarized?
It is a BMI # 092A108B250BD4A
I found this site:
http://www.bmicaps.com/miniaturecapacitors.aspx?EcommerceCategoryID=1697
> You got a capacitor from ACE Hardware? What a country!
> It should be non-polarized, though, if it's really an AC capacitor...
> -WB2WIK/6
>
> May I use a 108-130UF 250VAC polarized electrolytic
> starting capacitor from ACE hardware to replace the
> bad one in my CDE/HamII rotator control box?
>
--
Thanks! & 73, doc, KD4E
Personal: http://bibleseven.com/kd4e.html
Ham QTH: http://bibleseven.com/steel/cjb-steelhouse-index.html
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|