Bob
I have one installed in a T2X for about 2 years now.
Works fine when driven with a true serial card or an USB to serial port.
Installation and operation worked fine following manuf. instructions
Byron, W3WKR
----- Original Message -----
From: <BobK8IA@aol.com>
To: <towertalk@contesting.com>
Sent: Saturday, September 08, 2007 1:52 PM
Subject: [TowerTalk] Idiom Press RotorCard - Yaesu DXA
> Tower Talk folks;
>
> Any of you use the Idiom Press RotorCard - Yaesu DXA, for control of a
> Yaesu
> G-2800DXA rotator? Product reviews on eham.net seem good, but hardly
> anyone
> giving a review is familiar to me, like a lot of the TowerTalkians are.
>
> The reason I am thinking of this product is to fullly integrate my wife's
> (N7RQ) station into my shack, giving her a separate operating position
> like
> she's been used to. That card should allow her to serially tie her
> computer to
> the normal Yaesu control box on my desk, about 8 ft away. So the two of
> us,
> ideally, could share a single rotator box, without either one of us
> leaving the
> operating position.
>
> The price of this card seems very inviting, especially considering
> Yaesu's
> alternative.
>
> Questions:
>
> 1. Looks easy to install. Comments?
>
> 2. Any problems with operation? Maintenace?
>
> 3. This device still allows manual operation, correct?
>
> Tnx to all!
>
> 73, Bob K8IA
>
>
>
>
> ************************************** See what's new at
> http://www.aol.com
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|