Work is close to completion on the ham shack at EI/W5GN, and I need
suggestions on how to create a feed thru for the RF and Control Cables for
the antennas and (eventually) tiltover tower. They will be pulled thru only
when we are here and will be removed and the feed-thru sealed when we're not
here.
The concrete wall is 14 inches thick, and my contractor says he can easily
drill a 3 inch hole thru that wall, about
12 inches above the ground level.
I need about 3 inch diameter so the DB25 for the BigIR controller can be
pulled thru, but the actual cable cluser will probably be only about an inch
in diameter, as I'm strictly low power from here.
So my concerns are:
a. How do I "seal" with something that is removable
when the cables are in place to prevent wind-driven-rain
and the wind noise (we are on a bluff on the Atlantic).
I thought (briefly) about using expandable foam, but
past experience suggests it would NOT be easily removed.
Rags seems to be the current thought.
b. How do I seal the "hole" when we're not here.
I've though about using a threaded pipe with caps
both inside and outside, but don't know how
reusable the threading will be, especially exposed
to the salt water environment.
c. Assuming a metal pipe is use, is it important to
bend the outer end downwards, or will horizontal
work? I don't think PVC pipe can be threaded and
be reused?
73
Barry, EI/W5GN
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|