I use a small piece of nylon cord about 1/8 inch diameter. Take several half
hitches around the cable a few inches apart. Put several black tywraps
around the cable between the half hitches. Tape over it. Tie the upper end
to some secure point.
I have been doing this for years and no problems. It works for rotator cable
also.
73, Dan, N5AR
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com]On Behalf Of Roger Cooke
Sent: Saturday, December 01, 2007 11:01 AM
To: towertalk@contesting.com
Subject: [TowerTalk] Gamma fixing
Hi.
This is the third time I have lost my gamma wire on my 110ft tower! I
have an
18 inch spreader clamped to the tower and another two spaced down the tower.
I fix an old piece of coax at the top and just feed it through insulators in
the other
two spreaders down to the bottom. The way I have fixed it is to solder the
outer
and inner together onto a large solder tag, a very large and solid one. I
then fix
this to the loop of the spreader at the top. The inherent problem is the
weight of
the coax, since it just hangs on that solder tag. The wind eventually causes
it
to fail and the gamma just falls away, quite annoying, since I have to climb
the
tower again and take 110ft of coax with me and fix it.
I would like to hear of some variations on this theme so I can modify my
fixing method! How do you do it?
73 de Roger, G3LDI
Regards from Roger, G3LDI
Swardeston, Norfolk.
---------------------------------
Sent from Yahoo! - the World's favourite mail.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|