Hi all,
I have 1 3/4" od x 1/8" or 1/4" wall 6061-T6 aluminum up to 24 feet, pricing
is at
www.Penninger.com .
73
Charles, KC9DAO.
^
^
----- Original Message -----
From: "Bill Howell" <mrbillmac@gmail.com>
To: <towertalk@contesting.com>
Sent: Tuesday, December 11, 2007 3:16 PM
Subject: [TowerTalk] Vendors for 1 3/4 inch mast material?
>I have a Rohn top section which has an OD of 2 inches, so it will only
> accept a 1 3/4 inch mast inside it.I've found vendors on the web for 2
> inch
> mast, but none for 1 3/4 inch.
>
> Does anyone out there have a link for the smaller diameter mast material?
>
> Thanks,
>
> Bill Howell N5ALO
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|