Larry et al:
When I ordered my connectors from Harger (www.harger.com ) back in
2001, I ordered directly from the factory. I was able to buy the few
connectors I needed for my own use; there was no minimum at that time.
Since then I understand they have gone to a distributorship arrangment.
Buyers must now contact one of these folks to place an order. I'm guessing
that a minimum order will be required, but I don't know for a fact.
I must say that the connectors are well made and are exactly what I
needed to make quality connections to my Trylon tower. They will also work
for any angle- steel or -aluminum tower Hams might install. They are worth
the effort needed to buy them.
73 de
Gene Smar AD3F
(The usual commercial disclaimer applies.)
----- Original Message -----
From: "Larry Burke" <wi5a@sbcglobal.net>
To: "'Gene Smar'" <ersmar@verizon.net>
Sent: Friday, December 14, 2007 10:34 AM
Subject: RE: [TowerTalk] 160m Antenna Planning
Gene....
Those 222T connectors look just like what I am going to need to ground my
tower. Does Harger accept direct orders or do you have to work through one
of their distributors? Did you have to order a box of 10 or can you get in
smaller quantities? Any minimum orders?
Thanks,
Larry K5RK
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|