[TowerTalk] Yaesu rotator bolt (mast pin) replacement

[Tony <dxdx@optonline.net>]

All,

Need a replacement for the bolt used to pin the mast on my Yaesu 
rotator. It's a socket head cap bold measuring 8mm x 95mm. There was a 
break in the bolt where rust had set-in; thinking of going stainless.

Any suggestions?

Tony -K2MO


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk