Bob,
I used tools and supplies very similar to those used by DX Eng. and if
correctly installed, provide a very good connector installation.
Doug
Subject: Re: [TowerTalk] RG-6 connector issues/ rcv array
Mike -
Are you using the connectors, crimp tool, and cable supplied by DX
Engineering? I have their crimp tool and connectors but found them very
hard to use and was not confident about the resulting installation. In
defense of DX Engineering I have not contacted them and discussed the
issue,
I just gave up and used the RG-6 connectors I'm used to. Just curious
what
you're using.
73, Bob - W3YY
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|