I picked up a set of the 45/55 Anti Climb plates from a local ham for $110.
The were unused but I went ahead and had them re-galvanized along with 130
feet of Rohn 45-G tower sections. The plates are quite a few years old and
are very heavy (1.7 mm thickness). The one side has small round holes
approximately 3.7 mm and the other side that is angled the holes are
approximately 6.5 mm high and approximated 10 mm wide. I haven't used them,
but if do, I would use threaded SS hex head screws. I don't think there
would be any damage if you don't oversize the bolts. Fred AB8AH
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Daron Wilson
Sent: Saturday, March 29, 2008 2:26 PM
To: 'Roger (K8RI)'
Cc: towertalk@contesting.com
Subject: Re: [TowerTalk] Rohn 45 55 anti climb
Daron Wilson wrote:
>> Anyone used the Rohn anti climb sheets on 55 or 45? I've got them and a
>> bunch of 55 tower, all I can tell from the sheets is that you stand them
up
>> around the tower and sheet metal screw them to each other. I guess you
just
>> build this triangle around the base and let it rattle and bang around in
the
>> wind?
>>
>Reading your other posts and the reluctance to drill holes in the hot
>dipped galvanized sheeting how about "banding". You are looking at a
>permanent installation, and preferably one that is "Quiet". You might
>have to hunt to find the best material which ranges from painted steel
>(strong but probably not the best in this case) to various synthetics
>which are also strong but I don't know how any particular one would
>stand up to UV. It might be something that would have to be redone on a
>periodic basis.
>If the sheets are a bit too large to band you could use painted wood
>blocks or even pieces of tires as spacers using care they don't become
>water collectors that could cause rusting of the tower.
>You should be able to rent the tools and purchase how ever much material
>you use, but not being a high use item they may be difficult to find.
Thanks, as I said I can find many ways to do it better...and have on other
installations. What I'm trying to find, since I can find nothing in the
Rohn catalog about installation of this product, is what the real design
was. Having 100 pounds of sheet metal screwed together and not electrically
bonded to the tower but clanging around the base doesn't sound like a
reasonable design to me. Yes I could use stainless banding material, I
could make spacers between the product and the tower, and I'll likely have
to make a bonding jumper from each section to the tower ground. If you've
dealt with engineered work, the common statements are 'must be installed to
manufacturer's specifications' and 'must meet all applicable codes'. I'm
trying to head off the question from the electrical engineer when he shows
up to inspect this floating, un-bonded sheet metal around the base of the
tower and asks why it isn't attached and bonded.
Thanks,
Daron N7HQR
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|