Towertalk
[Top] [All Lists]

Re: [TowerTalk] Tri-Ex WT-51 Electric Winch with Pulldown Mechanismand R

To: <chasm@texas.net>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] Tri-Ex WT-51 Electric Winch with Pulldown Mechanismand RMC-1000
From: "Dan Hearn" <dhearn@air-pipe.com>
Date: Wed, 9 Jul 2008 15:47:21 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Actually the dangling pull down cable is attached to the bottom of the top
section and comes down inside the tower. I lower the tower in 15-20 ft steps
and then pull the cable outside the tower at the bottom. I also pull the
coaxes out at the same time. Believe me, side wind force can cause a tower
section to stick in spite of its weight. It has happened to me. Of course if
you wait until the wind ceases you have no problem. If the section sticks
and you continue lowering, it will come loose and cause a big jerk on the
cable.  I believe a remotely controlled tower, that you can not see, without
power pull down, is a potential disaster situation.
73, Dan, N5AR
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com]On Behalf Of chasm@texas.net
Sent: Wednesday, July 09, 2008 3:15 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Tri-Ex WT-51 Electric Winch with Pulldown
Mechanismand RMC-1000

Dan Hearn wrote:
>   I think it is foolhardy to raise or lower a crankup when you are not
> watching it and in control of the operation. I have had a coax snag and
pull
> in two even when I am watching but not as observant as I should be.
>   73, Dan, N5AR

Could not agree more.  still not sure why a pulldown is necessary as
gravity should certainly handle it and as Dan states, if you are not
out there to the side walking around with the remote in your hand, you
are likely to bung up your alignment or suffer other mishaps. I do
like the idea of a line hanging from the mast base to put pressure
against the wind.  really like this list.

I am still trying to find a 110VAC winch for about the same price as
the 12VAC with remote sold by Stanley or Masterlock, I forget
which..about $70.00  I suppose I could use my emcomm battery set to
run the winch since the 110V is just NOT going to be found.<G>.

73de chas/k5dam

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>