Alphabetical has always worked to me!
Bob W7KD
----- Original Message -----
From: "RICHARD SOLOMON" <w1ksz@q.com>
To: <towertalk@contesting.com>
Sent: Monday, August 04, 2008 7:07 PM
Subject: Re: [TowerTalk] Tailtwister Rotor wires
> One of the locals had a great scheme, once you connect the larger
> motor wires the rest follow the Resistor Color Code (B-B-R-O, etc).
>
> No need to write anything down.
>
> 73, Dick, W1KSZ
>
>
>
>> From: k5fnq@cox.net> To: towertalk@contesting.com> Date: Mon, 4 Aug 2008
>> 20:46:39 -0500> Subject: [TowerTalk] Tailtwister Rotor wires> > OK, I
>> admit to screwing up. but it was for a good cause.> Local was doing tower
>> work and had rotor problems. I volunteered to come > home and get my TX2
>> control box in case his was bad.> I wrote down the color code when I took
>> off the wires and have now lost the > little piece of paper I used.> > I
>> think I have it right as the manual has the color codes, it has just been
>> > up too long to be sure.> > I see in the manual a way to check
>> resistance on the wires.> Is this the only way to try and figure out the
>> wiring or do I have to get > someone up the tower to check?> Yeah it was
>> a dumb move, but all for a good cause at the time.> Art K5FNQ> >
>> _______________________________________________> > > >
>> _______________________________________________> TowerTalk mailing list>
>> TowerTalk@contesting.com>
>> http://lists.contesting.com/mailman/listinfo/tow
> ertalk
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|