Towertalk
[Top] [All Lists]

Re: [TowerTalk] Window feed throughs

To: n8de@thepoint.net
Subject: Re: [TowerTalk] Window feed throughs
From: chas <chasm@texas.net>
Date: Thu, 09 Apr 2009 13:09:07 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
n8de@thepoint.net wrote:
> The problem in weathersealing this 'contraption' is NOT at the window  
> opening, it's at the place where the two window sections overlap.    
> Without adequate sealing there, the snow will blow right through that  
> 'crack'.  (Spoken from experience.)
> Best method is to replace the movable section of window with a large  
> Lexan sheet and seal it around every edge.  (been there, done that)
> Don
> N8DE


personally, I threw money at it and moved on.
it comes a little bit over length for my window but with sealant foam 
(closed cell.  for the over lapped window problem, I rolled and 
stuffed small cell bubble wrap down between the overlapped then DUCT 
taped the inner top edge and the outer bottom edge.  all of that or 
course, was over kill as the properly done bubble wrap was a complete 
solution in itself.

I then did a few other things like drilling a hole for a 240v line 
from the shop building 10' outside my shack window which runs both of 
my amps.  Another hole for 20a 120V for all the rest of my rigs so 
that they are isolated from the house wiring.
I also fed a line for my antenna switch box on teh tower along with 
control cable and used one 239 bulkhead for the feed to that box.

I still have a couple more for my PAR 6 m stacked and my VHF/2m 
vertical and my 2m yagi.

As I said, MFJ has it all there, already, all I had to do was to drill 
a couple of holes, cut it to length insulate and it has been good to 
go for a couple of years now.  including three hurricanes.

chas, Houston
k5dam
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>