Towertalk
[Top] [All Lists]

Re: [TowerTalk] Rohn 20/25G leg insulator material

Subject: Re: [TowerTalk] Rohn 20/25G leg insulator material
From: "Roger (K8RI)" <K8RI-on-TowerTalk@tm.net>
Date: Mon, 13 Apr 2009 20:36:19 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>

Mark Robinson wrote:
> The consensus was to use solid FR4 G10 rod.
>   
I wonder about that as ground fiberglass is sensitive to degradation by 
moisture and UV.

> These guys sell it and I believe that they can do the machining required.
>
> http://www.jjorly.com/g10_rod_rods.htm
>   
I think I also saw a $250 minimum order.

73

Roger (K8RI)
>
> ----- Original Message ----- 
> From: "Allen R. Brier" <n5xz@earthlink.net>
> To: <towertalk@contesting.com>
> Cc: "'Rick Hiller'" <rhiller@sdicgm.com>
> Sent: Monday, 13 April, 2009 3:39 PM
> Subject: [TowerTalk] Rohn 20/25G leg insulator material
>
>
>   
>> I wish to build an 80 meter vertical using some Rohn 20G sections I have in
>> storage. In the past there was some mention of insulating material that
>> could be used at the base. If possible, I would like to get that 
>> information
>> again from the group. I would like to make the vertical self supporting 
>> i.e.
>> no guys (bosses request). Will the material be strong enough for that?
>>
>> In addition, what would be a good recommendation for the vertical
>> configuration, i.e. how many 20G sections and how much of a stinger on 
>> top?
>> Obviously maximum bandwidth and efficiency is the goal and I operate 
>> mostly
>> CW.
>>
>> Next, I would also like to consider using the same antenna on 160 meters, 
>> by
>> switching in a loading coil at the bottom. I know this isn't optimal, but 
>> I
>> would like some recommendation for how much inductance in would need, or 
>> the
>> coil configuration (full legal limit, of course). Other recommendations
>> would also be appreciated.
>>
>> Finally, I also have a 70 foot crank-up tower with a 4-el SteppIR on top
>> that could be shunt fed. If I did shunt feed the tower, what would be the
>> optimal distance between them for phasing purposes?
>>
>> A lot and questions in one email but I would appreciate any and all 
>> advice.
>>
>> 73,
>>
>> Allen Brier N5XZ / KL5DX
>> 1515 Windloch Lane
>> Richmond, TX 77406-2533
>> 281-342-1882
>> 713-705-4801 (Cell)
>> n5xz@arrl.net
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk 
>>     
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>   
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>