Towertalk
[Top] [All Lists]

[TowerTalk] G 1000 DXA alignment?

To: towertalk@contesting.com
Subject: [TowerTalk] G 1000 DXA alignment?
From: jim Jarvis <jimjarvis@optonline.net>
Date: Sun, 31 May 2009 15:22:15 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Anybody got a foolproof alignment procedure for a Yaesu g1000dxa rotor?

I replaced the motor in this thing, like 7 years ago, and it's been  
on the shelf  ever
since.   Have now confirmed that it rotates in the correct direction,  
and over 450 degrees
travel.

The control box indicator doesn't align with the rotor.

Note that all possible variables have been diddled with,  including  
removal of
the sending pot and tweaking of the calibration, and moving of the  
pointer.

I WAS methodical about this, way back when... not moving the  
alignment pot,
nor the cal nor the pointer... but when assembled it wouldn't rotate  
through 450 degrees.
So I shelved it.

Careful reassembly, paying attention to the stops restored  
rotation.   But the pointer is off.
I tried aligning everything to North... but that didn't work at the  
extremes.   So I tried aligning
to the left 180 degrees... and that wouldn't align going to the  
right, to the overlap stop.

I have the feeling I'm getting close on this, but clearly I'm missing  
some relationship.

At this point, I'm sure the proper procedure for motor replacement  
begins with
"mark upper and lower casings at the point of the cast alignment  
hacks..."
Naturally, I didn't start with that, but I think I've reconstructed  
it, given that we're rotating ok.

Suggestions welcome.   Thanks, in advance.

N2EA@arrl.net



_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>