Towertalk
[Top] [All Lists]

Re: [TowerTalk] The right tower

To: "'TowerTalk'" <towertalk@contesting.com>
Subject: Re: [TowerTalk] The right tower
From: "W5LT" <W5LT@verizon.net>
Date: Thu, 10 Sep 2009 22:40:39 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Ron:
You might consider the Heights tower series with Fold-Over kit.

See: http://www.heightstowers.com/fold_over_kits.htm

You can ?build your own? in whatever height and antenna capability you need.

Bob, W5LT

From: SteppIR@yahoogroups.com [mailto:SteppIR@yahoogroups.com] On Behalf Of
Joe - WDØM
Sent: Thursday, September 10, 2009 2:49 PM
To: w4lde@numail.org
Cc: TowerTalk; SteppIR Yahoo Group
Subject: [SteppIR] Re: [TowerTalk] The right tower

  
The US Tower TX-455 has a tilt over option. My tower has withstood 90 
mph gusts with a SteppIR 4L with the 30/40 add on. I also have the 
NN4ZZ TiltPlate that brings everything down to ground level - no more 
climbing. 

My web page has some pictures of the installation and how easy it is to 
work on the antenna system.

http://www.wd0m.com

Hope that helps!

73
-- 

Joe WDØM
Pagosa Springs, CO
HTTP://www.wd0m.com

w4lde wrote:
> I was getting ready to order the US Tower MARB-550 55ft tubular tower 
> and first decided to look once again at the US Tower WEB site for ratings.
>
> US Tower has updated there web site and now has new HAM tower 
> brochures. The Tubular towers (550) now only show a 10sq' rating based 
> on 50MPH.
>
> My plan is to mount a SteppIR 3-element with the 30/40 meter kit which 
> runs about 8 sq'. I am in a 70MPH zone. 
>
> I check out several catalogs online one being Texas Towers and they 
> still show that same 9 sq' rating at 70mph and 22sq' at 50mph.
>
> The base is poured but so be it if I have to change.
>
> I am getting up in years and my climbing days are over, I was also 
> planning on the tilt over accessory from US Tower. 
>
> I have looked at the Aluma tower crank up and with guys is rated at 
> 80mph at 25sq ft. Its also available with a tilt over base.
>
> If there was a way to guy the MARB I would feel much safer? To go with 
> the Aluma is a 40% add but maybe worth the money in the long run.
>
> If a tilt over assembly was available through US Tower for the TX or 
> the HXD series then I would go that route. Not shown on web site. Also 
> the TX and HXD are now rated at 50mph but I would have enough safety 
> margin with either at 70mph.
>
> Need to get on with it before the next solar cycle comes and goes hi 
> hi. Any advice or comments are welcomed.
>
> 73 de
> Ron W4LDE

[Non-text portions of this message have been removed]
__._,_.___
Messages in this topic (2) Reply (via web post) | Start a new topic 
Messages | Files | Photos | Members 

Change settings via the Web (Yahoo! ID required) 
Change settings via email: Switch delivery to Daily Digest | Switch format
to Traditional 
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe 
RECENT ACTIVITY
?  8
New Members
?  25
New Photos
Visit Your Group 
Give Back
Yahoo! for Good
Get inspired
by a good cause.
Y! Toolbar
Get it Free!
easy 1-click access
to your groups.
Yahoo! Groups
Start a group
in 3 easy steps.
Connect with others.
.

__,_._,___
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.409 / Virus Database: 270.13.83/2353 - Release Date: 09/10/09
11:29:00

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>