I use a Kenpro KR2000 (built before Yaesu bought out Kenpro rotators) which
is essentially
the same as G2800DXA and I have always used a standard rotator plate with it
on 25G, 45G,
and other towers. Getting it into a 25G is a bit more of a challenge of
course.
73, Larry W6NWS
----- Original Message -----
From: "RICHARD SOLOMON" <w1ksz@q.com>
To: "TowerTalk" <towertalk@contesting.com>
Sent: Monday, September 14, 2009 1:58 PM
Subject: [TowerTalk] G-2800DXA Rotor Plate for Rohn 25
>
> I want to mount a Yaesu G-2800DXA inside a section of Rohn 25.
>
> Does anyone make a pre-drilled rotor plate for this combo ?
>
> A Google search came up wih several hundred thousand hits of
>
> which not many dealt with my specific need.
>
>
>
> If I had a drawing of the Rohn Rotor plate I could check to see
>
> if it would do. All the listing said was ..."Yaesu"... . Not very
>
> specific.
>
>
>
> Thanks, Dick, W1KSZ
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|