Towertalk
[Top] [All Lists]

Re: [TowerTalk] Insulators

To: n8de@thepoint.net
Subject: Re: [TowerTalk] Insulators
From: "Roger (K8RI)" <K8RI-on-TowerTalk@tm.net>
Date: Sat, 10 Oct 2009 03:12:39 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>

n8de@thepoint.net wrote:
> FYI:
>
> I discovered a new source for insulator material that I will be using  
> on my 80m tower verticals.
>
> At the local 'feed store', I found 1+1/4" fiberglass ROD with a few  
> small pre-drilled holes ... it's designed to be used as an electric  
> fence post.  The rod is VERY STRONG and should hold up quite well.
>
> The cost for a 6' rod is about $6 .... quite inexpensive.  Cutting it  
> into 6+" lengths is quite easy.
>
> CAUTION:
>   
NEVER Cut, drill, or sand  fiberglass without wearing a *respirator*

73


Roger (K8RI)
> When handling this item, WEAR GLOVES as the fiberglass is RAW and will  
> leave microfibers in your SKIN.
>
> When CUTTING it or DRILLING it ... wear EYE PROTECTION.  You won't  
> like the effect should any 'flakes' get in your eyes.
>
> Tower/antennas going up next week .. .FINALLY.
>
> Don
> N8DE
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>   
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>