That worked Karl. Tnx!
Paul, W9AC
----- Original Message -----
From: "Rick Karlquist" <richard@karlquist.com>
To: "Roger (K8RI)" <K8RI-on-TowerTalk@tm.net>
Cc: "Paul Christensen" <w9ac@arrl.net>; <towertalk@contesting.com>
Sent: Monday, November 30, 2009 6:03 PM
Subject: Re: [TowerTalk] Open wire lines
You can also try holding down the "Alt" key while
typing "253" or "0178" on the numeric pad. I'll try it
here and see if it survives the reflector:
Zo²
I'm seeing a superscript 2 in my plain text mailer window
running Courier font.
For superscript 3, use Alt 0179.
Subscript zero is Unicode 2080 hex, but there is no way to
finagle that into a plain text system, AFAIK
Rick
N6RK
Roger (K8RI) wrote:
>
>
> Paul Christensen wrote:
>>> ZS = Z02 / ZL
>>>
>>
>> I guess the Towertalk reflector cannot pass extended ASCII characters.
>>
>> The Z02 is actually Zo squared and not Zo * 2. I tried to send a raised
>> "2"
>> but no go.
>>
> Try ZO^2 which is an accepted way of writing exponents when the super
> script is not available.
>
> 73
>
> Roger (K8RI)
>> Paul, W9AC
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|