Hi Jorge,
You get the dimension in mm (millimeter) if you multiply the inch by 25.4
(exactly) as one inch, by definition, is 25.4 mm. The ID 1.020" of the
2X31-1081P2 is equal to 25.908 mm enough for several cables :-).
73 de Hans - N2JFS
-----Original Message-----
From: Jorge Diez - CX6VM <cx6vm.jorge@adinet.com.uy>
To: 'Tower and HF antenna construction topics.' <towertalk@contesting.com>
Sent: Wed, Feb 10, 2010 9:03 am
Subject: [TowerTalk] beads for keyboard or microfone cable
Helloor,
I will order a snap on beads to add in the keyboard, microfone, mousse,
interfaces cables.
I think the 31 material https://www.amidoncorp.com/items/6 will be OK, but
not sure about the dimensions because I am not familiar with inches
dimensions.
Wich one do you think will be OK to do 4-6 turns with the keyboard, mousse,
microphone, interfaces wire?.
I think is a AWG#12 wire.
Thanks!
73,
Jorge
CX6VM/CW5W
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|