A Ham IV fits but a TX2 does not. I had to cut one piece of the thinner
support to get it in after the sections were raised.
Bill Marx W2CQ
On 11/3/2010 10:10 AM, Mark Robinson wrote:
> Here is the 25AG section
>
> http://www.3starinc.com/rohn_25g_top_cap_tower_section_r-25ag.html
>
> I have a similar 3 foot section and my Ham IV fitted in there fine.
>
>
> Mark N1UK
>
> ----- Original Message -----
> From: "Dennis Vernacchia"<n6ki73@gmail.com>
> To: "towertalk"<towertalk@contesting.com>
> Cc: "CQ-Contest"<cq-contest@contesting.com>
> Sent: Tuesday, 02 November, 2010 5:09 PM
> Subject: [TowerTalk] Will a Ham IV Rotator fit inside a Rohn 25 tower
> tipsection ?
>
>
>> A friend e-mailed me that he has a 25AG section
>>
>> I used to recall Rohn 25G
>>
>> not a clue what an AG nomenclature means and if that means a Ham IV will
>> fit
>> inside section ?
>>
>> 73. Dennis
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|