I tried it. It is springy enough that where my yard has dips it pulled out
of the shallow cuts I made. That exposed them to the deer who stepped on
them and broke them. Then I ran over the exposed ends with the mower and
pulled some out with rather spectacular results to the spindle of the mower
deck and bits of Kentucky clay flying up into the air.
All my new radials are copper.
Clint Talmadge ? W5CPT
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Peter Sils
Sent: Thursday, December 30, 2010 6:46 PM
To: towertalk@contesting.com
Subject: [TowerTalk] Using aluminum wire (or aluminum clad) - for buried
radials?
Gents,
What are your thoughts about using this for buried radials?
Your thoughts would be greatly appreciated!
73 Peter
KD0AA
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|