Barry
"Single rivet"? My C31XR had 3 per joint.
73 Larry K1ZW
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Barry
Gross
Sent: Friday, February 18, 2011 12:02 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Force12 rivets
Thanks for all the advice! What I think I'll eventually do when I get the
antenna down, is drill
perpendicular holes one inch proximal (boomward) to all the existing single
rivets and add a second
rivet.
73, Barry N1EU
On Fri, Feb 18, 2011 at 4:07 PM, Mickey Baker <fishflorida@gmail.com> wrote:
> Careful drilling "perpendicular holes" - better to go down the length
> of the tubing a few cm so as not to provide a weak point in the element.
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|