> You hook up a water hose to the top and just wash it into the ground like
> a drilling rig does. It will go down easy just a little up and down motion
> and away it goes. Put 9 feet in the ground in about 10 min.
>
> Charles F. Frost
> Frosty K5LBU
> frosty1@pdq.net
>
>
> ----- Original Message -----
> From: "Dan Bookwalter" <n8dcj@yahoo.com>
> To: <towertalk@contesting.com>
> Sent: Wednesday, May 25, 2011 7:28 AM
> Subject: [TowerTalk] Copper Pipe Ground Rods - Driving them in - How ?
>
>
>> Ok , I have most of my ground system planned out , my plan is to use
>> copper pipe
>> (type "L") and silver solder flashing to them from the tower etc... my
>> issue is
>> how in the world do you guys drive copper pipe into the ground , I have
>> access
>> to a 1/2" hammer drill , but , the pipe is too large for that , I am
>> going to
>> check into a ground rod bit for it , but , I am still not so sure if that
>> will
>> work.
>>
>> Suggestions ??
>>
>> Dan N8DCJ
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|