Almost forgot--you will likely need limit switches too.
Sent from my iPhone
On Jul 2, 2011, at 9:21 AM, Eric Dobrowansky K2WD <k2wd@comcast.net> wrote:
>
>
> Good afternoon,
>
>
>
> I recently suffered a lightning strike to an antenna on my tower, and my
> OR2800 now indicates 16 ohms on the two motor wires (pins 1 &2), which looks
> normal. However the reed switch is showing a continuous short across pins 5&6
> even while getting the rotor turn ever so slightly before the controller
> faults to E1.
>
>
>
> How difficult is it to replace the reed switch. Obviously I'm guessing the
> rotor needs to come out of the tower. But is it easy enough to disassemble
> the OR2800 and get to the reed switch? Also, is it available from places like
> Mouser or Digi-Key, or is it a custom part that will require me to order it
> from M2?
>
>
>
> Any web pages showing the inside?
>
>
>
> Thanks
>
>
> Eric
> K2CB
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|