Figure as part of the vertical length.
Best - alan K9MBQ
-----Original Message-----
>From: WW3S <ww3s@zoominternet.net>
>Sent: Nov 6, 2011 10:36 PM
>To: towertalk@contesting.com
>Subject: [TowerTalk] phased vertical feedpoint question
>
>Planning on phasing 2 40m verticals....using Dx Engineering radial plates
>with bulkhead connectors and their 19" coax pigtail....should I figure the
>19 inch length into the phasing line calculations?
>
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|