Not if the coax shield is grounded at the antenna end.
73
Don
N8DE
Quoting Alan Swinger <awswinger@earthlink.net>:
> Figure as part of the vertical length.
> Best - alan K9MBQ
>
>
> -----Original Message-----
>> From: WW3S <ww3s@zoominternet.net>
>> Sent: Nov 6, 2011 10:36 PM
>> To: towertalk@contesting.com
>> Subject: [TowerTalk] phased vertical feedpoint question
>>
>> Planning on phasing 2 40m verticals....using Dx Engineering radial plates
>> with bulkhead connectors and their 19" coax pigtail....should I figure the
>> 19 inch length into the phasing line calculations?
>>
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|