Doug
No problems here with Eco 15 and N types. I have it on two rotator loops of
about the size you mention.
John G4ZTR
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Doug Turnbull
Sent: 19 January 2012 19:51
To: towertalk@contesting.com
Subject: [TowerTalk] Ecoflex 15 questions
OMs
I am wondering just how flexible Ecofllex 15 coax may be. Can I use
this coax successfully for a rotator loop of about 3.5 feet taking 7.0 feet
of coax without causing the coax difficulty? It is a much less flexible
coax than RG-213 but I am able to provide a fairly loose loop.
The centre pin is not soldered on their special PL259 plug but instead
uses a compression fitting. Does this present a problem? For that matter
the braid is not soldered either but uses a compression fitting somewhat
similar to that of a Type N connector. Has anyone experience with this
coax and what is the verdict on these connectors?
Thank you for your advice.
73 Doug EI2CN
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
__________ Information from ESET NOD32 Antivirus, version of virus signature
database 6810 (20120119) __________
The message was checked by ESET NOD32 Antivirus.
http://www.eset.com
__________ Information from ESET NOD32 Antivirus, version of virus signature
database 6810 (20120119) __________
The message was checked by ESET NOD32 Antivirus.
http://www.eset.com
__________ Information from ESET NOD32 Antivirus, version of virus signature
database 6810 (20120119) __________
The message was checked by ESET NOD32 Antivirus.
http://www.eset.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|