The suggestion about connections was a good one. My G-1000DXA was erratic like
that.
Turned out the cable wasn't plugged all the way in the back of the control box.
73, Mike NF4L
> Hi all,
>
> My Yaesu G-1000DXA rotator has started acting weird.
>
> If I turn it clockwise, say to 180 degrees, the needle goes around to 180
> degrees but when I take my finger off the button the needle jumps back to
> 150 degrees. This is fairly consistent, although occasionally it jumps back
> less than 30 degrees and sometimes it doesn't jump at all.
>
> When I turn it counterclockwise, the needle initially moves 10 or so degrees
> clockwise, then starts around counterclockwise as it should. But when I take
> my finger off the button, the needle continues on clockwise for another 10
> or 20 degrees.
>
> Checking the antenna, it appears to be pointing in whatever direction the
> needle ends up pointing after all its gyrations.
>
> Anyone ever had a G-1000 behave like that? Any suggestions as to whether the
> problem might be in the control box or the rotator? Any help on what to do?
>
> John
> N6ZAE
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|