Greetings!
Has anybody here done a retrofit motor drive to run a TX-472 up. I did a
modification on the hand winch with a coupling nut on both the tower and
raising fixtures. Using a drill I am able to get the raising fixture to lift
the tower up quite nicely. However the tower itself just weighs too much for
the same drill to run the tower up. The drill won't budge it. I was thinking of
using an impact wrench but am not certain if this would be appropriate.
thoughts!
Thanks & 73
Wayne C.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|