How many foot pounds of torque does the winch take when
cranking by hand? My Milwaukee drill can do over 50 foot pounds
(as measured by a torque wrench). The DeWalt looks good on
paper (although it is 7 amps not 9 amps) and you would think
it would be as good as my Milwaukee. 50 foot pounds is a VERY
hard to turn hand winch.
Rick N6RK
Wayne Crawford wrote:
>
>
>
>
>
>
>
>
>
> The drill I am currently using is a DeWalt DW130 9 amp 1/2 inch. This
> drill was recommended by another Ham who was using one to run up a TX-455.
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|