Can help you here.
40 ft. Rohn 25 tower, custom tilt base, guy ropes from Mastrant, all anchors
are just 3/4 inch diameter steel rods pounded into the ground. The base takes
four 24 inch rods to just keep the base from moving. Quite simple, and uses a
basic boat winch to crank it up. An article will be coming out shortly that
describes the whole system.
The Tower system supports a couple of inverted vees (80 and 40 M) and the Cycle
24 TX-38 tribander that works fantastic! Turned by a Yaesu G450 rotor.
Since you may be local to New England, the heart of the WRTC 2014 event, you
and your radio club may be eligible to get a discount on the purchase of the
entire system if you volunteer to help during the event.
Regards,
Mark, K1RX
WRTC 2014 Organization
Director, Antenna and Tower Infrastructure
________________________________
From: Bud Kozloff <W1NSK@Hotmail.com>
To: towertalk@contesting.com
Sent: Saturday, July 28, 2012 3:52 PM
Subject: [TowerTalk] IARU Team Stations
Thinking of a "temporary" 35ft 25G Setup w/A4S on top similar to what
they are doing for the 2014 temporary team stations.
How are they installing the towers? Actually pouring foundations?
Putting a 10ft section in a 5ft hole and digging it out afterwards?
How are they installing the guys? Any info would be appreciated.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|