The last time I mounted my rotator at the top of my "rocket top" ears-up was
the only way it would work to allow enough room for the rotator. My latest
installation has the rotator at the bottom of the rocket-top and I mounted
it ears-down for a couple of reasons. One is that it gives me an extra inch
or so of height, which with my modest tower I need every inch I can get, and
the other is I've always kind of had the thought that with the ears down
water is less likely to pool on the plate and seep underneath the rotator.
But as others have said, I don't think it makes much difference either way.
Just make sure you put the rotator on the top side of the plate, HI HI.
73, Dave WA0TTN
> -----Original Message-----
> From: towertalk-bounces@contesting.com [mailto:towertalk-
> bounces@contesting.com] On Behalf Of Tom Davis
> Sent: Wednesday, August 15, 2012 10:51 AM
> To: TowerTalk@contesting.com
> Subject: [TowerTalk] Rotor mounting plate orientation
>
> I am probably over thinking this but is there a preferred orientation
("ears"
> up or down) when installing a Rohn 25G rotor plate? The rotor is a Ham IV
> and everything appears to fit either way.
>
> Tom
> K7TBM
>
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|