On Fri, Aug 31, 2012 at 1:22 PM, Dan Bookwalter <n8dcj@yahoo.com> wrote:
> I had to remove the terminal block on the bottom of the rotor , it was
> falling apart, i wrote down the wire colors as best as I could see them ,
> does anyone have the internal pinout to the backside of the terminal block ?
> with wire colors so I can confirm.
Not sure if the wire colours are consistent... it's not a very complex
schematic - you can find it near the end of the manual:
http://www.hamanuals.com/MMans/t2x.pdf
Should be easy enough to trace the wires....
73,
~iain / N6ML
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|