On 8/31/2012 4:22 PM, Dan Bookwalter wrote:
I had to remove the terminal block on the bottom of the rotor , it was falling
apart, i wrote down the wire colors as best as I
could see them , does anyone have the internal pinout to the backside
of the terminal block ? with wire colors so I can confirm.
IF you know which one goes where they could even be all the same colors.
Tail twisters with terminal blocks? All I've seen had a pig tail with
an inline connectors. IOW it doesn't matter, but if you want to do it
the way it was originally I just finished rewiring some Ham IVs and Vs
and used the Tail twister "pig tails".
I'll try to find the sheet they sent me, if no one comes up with a pin out.
73
Roger (K8RI)
Thanks
Dan N8DCJ
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|