Hi Steve,
Thank you for replying.
Does it reverts tapered back to single wire?
I want to model my current 20m tower + 40m moxon + 20m yagi to see how can
I load it as a vertical for low bands, so I want to move from tapered to
single wire as well.
73,
Felipe Ceglia - PY1NB
-------------------------------------------------------------------------------------
PR1T team member /// Rio DX Group member /// Araucaria DX Group member
http://dxwatch.com /// http://reversebeacon.net /// http://riodxgroup.com
On Tue, Nov 27, 2012 at 10:31 AM, Steve W3AHL <w3ahl@att.net> wrote:
> I use DX Engeineering's Yagi Mechanical. You design an antenna with a
> constant element diameter using EZ-NEC or similar. Yagi Medchanical is
> used to take that design and change the element taper schedule to achieve
> the required mechanical properties to withstand wind and ice loading. As
> you change the element taper it calculares the new resonate frequency of
> the element, so you can adjust the tip length to keep resonance the same as
> the original design.
>
> You can download a trial version and instruction manual from:
>
> http://www.dxengineering.com/**parts/dxe-sof-yagimech<http://www.dxengineering.com/parts/dxe-sof-yagimech>
>
> It has instructions on how to install for Windows 7. Cost is $39 US.
>
> Steve, W3AHL
>
> Hi folks,
>>
>> I'd like some advice on software, scripts or ways to convert single
>> diameter tubing into tapered element, and back.
>>
>> I've been advised to try ON4UN's software, but I could not run it on
>> windows7.
>>
>> Thanks,
>>
>> Felipe Ceglia - PY1NB
>>
>
> ______________________________**_________________
>
>
>
> ______________________________**_________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/**mailman/listinfo/towertalk<http://lists.contesting.com/mailman/listinfo/towertalk>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|